Cabins

An aircraft can be nearly full in one cabin and have plenty of empty seats in another. Looking at cabins separately helps you see differences that disappear in the carrier-wide average.

You can read about the underlying data and how to collect it in Cabins.

Cabin Load Factors

The Europa demos have one cabin, Y, so this example produces a single cabin panel. With a multicabin network, the same method adds a panel for each cabin in your results.

This chart shows load factors for each carrier and cabin. It is useful when you want to check whether one cabin is filling up while another still has room.

The values come from the cabins table. Use raw_df=True if you want to inspect the data behind the chart.

For one run, call fig_cabin_load_factors on a single SimulationTables object:

summary.fig_cabin_load_factors()

To compare scenarios, make this chart once for each result. There isn’t a combined comparison method for this figure.